djh
New Member
Posts: 36 
|
Post by djh on Mar 14, 2018 15:28:52 GMT
Does anybody know of a good downloadable tool library that can be imported into Fusion and accessed in CAM tool selection tab??? The available tool library doesn't seem to have many options, but a lot of drill sizes. Am I missing something or in the wrong library???
|
|
|
|
Post by Derek the Admin on Mar 15, 2018 11:19:16 GMT
There should be a lot of end mill sizes. Are you certain you don’t have just drills selected?
There will be a lot of drills amongst the others though.
|
|
|
|
Post by Bones M&E on Mar 15, 2018 18:59:54 GMT
You can easly edit and save tools in Fusion, or edit a tool for odd use,
I needed to do a very tiny pocket removal on a coin sized project, the only bit I had with a small enough tip was the Vbit, I selected flat end mill, edited the tip and sizes, and used it in place of a tiny flat end mill, Worked fine.
|
|
