nicko
New Member
Posts: 7 
|
Post by nicko on Mar 17, 2018 19:14:09 GMT
Millright CNC M3: I try to initiate the Homing sequence with $H but I get a pop-up that says "error: Setting disabled". Is something not set correctly?
|
|
|
|
Post by notso on Mar 17, 2018 19:57:42 GMT
Check the GRBL setting s (if using UGCS it is under options machine settings or something)look for $22 it should say $22=1 if it says $22=0 then it is disabled, just change it. $23 should be $23=0 by default (top right is home) Below are default settings EXCEPT line $100 and $101 (these are my adjusted steps, your should say 40 until you finish fine tuning it)   |
|
|
|
Post by Derek the Admin on Mar 17, 2018 22:46:38 GMT
Thanks for helping out Notso.
|
|
nicko
New Member
Posts: 7
|
Post by nicko on Mar 18, 2018 3:28:14 GMT
Unfortunately my firmware settings dialog is blank. However, I did set $22=0 and so now the homing routine works. However, it won't go back to zero. It's a start though. Thanks! Attachments:
|
|
|
|
Post by notso on Mar 18, 2018 16:10:20 GMT
I think I will leave this for Derek since $22=0 should be DISABLED and allow it to work....
that and it came up blank might be an issue as well..
|
|
|
|
Post by Derek the Admin on Mar 18, 2018 17:14:25 GMT
What is it doing when it won’t go back to zero? What version of UGS are you using and what version of Grbl?
|
|
nicko
New Member
Posts: 7
|
Post by nicko on Mar 20, 2018 1:36:14 GMT
I think I've got it now. UGS Plateform v2 stable nightly build is what I was using. I switched to the Universal Gcode Sender v1.0.9 and all my settings show up. On a side note, does it matter if $22 is enabled or disabled?
|
|
|
|
Post by notso on Mar 20, 2018 2:33:15 GMT
It should. $22 is 1 for homing ON and $22=0 for homing OFF
|
|
