freik
Full Member
"What did you buy the new CNC Router for?" "To make stuff for my CNC Router!"
Posts: 107
Location: Bellevue, WA
Machine: Power Route
|
Post by freik on Mar 18, 2018 19:56:28 GMT
I figured I'd post the final setup. The 10 year old beater shop laptop is a little too big to sit there comfortably. I'll probably put a little foldout table on the front of the table later. I'd post it ripping through a project, but after traveling for work, I've forgotten where I put the collet for the router  (cleaning up and searching for that is my Sunday afternoon project...)   |
|
|
|
Post by Derek the Admin on Mar 18, 2018 20:31:28 GMT
Man that thing is a good looking machine!
Did you lose both collets? There is a half and a quarter in there.
Ready to see ya rip and run bud!
|
|
|
|
Post by Hommer Woods on Mar 18, 2018 23:09:07 GMT
Very nice setup.
|
|
|
|
Post by VGCustomShop on Mar 24, 2018 8:33:35 GMT
Awesome looking machine! Great job putting it together!
|
|
|
|
Post by ricko on Mar 24, 2018 18:38:38 GMT
Looks great, mine is about two days away from completion, ran into a few critical nut and bold shortages that stopped me.
|
|
freik
Full Member
"What did you buy the new CNC Router for?" "To make stuff for my CNC Router!"
Posts: 107
Location: Bellevue, WA
Machine: Power Route
|
Post by freik on Mar 25, 2018 1:48:18 GMT
ricko, yeah, I hit a couple of minor issues, as well. I cleaned out two of the nearby Home Depots of all their M5's  -Kev
|
|
(cleaning up and searching for that is my Sunday afternoon project...)
