UGS Error

[cplymill]

Hello everyone.  I have assembled the Carve King that I ordered and am trying to run a CAM created in Fusion 360. The file is attached. When I upload via UGS it says that there are unsupported commands. When I try the second time it runs without error. Any suggestions? 1001.nc (2.5 KB)

Also, can someone tell me the size of the Philips screw that tightens the DW611 mount?  I want to put in a hex head or some other screw that is not easily rounded.

Thank you and look forward to putting the carve king through its paces.

Clayton

Attachments:

1001.nc (2.5 KB)

[notso]

According to the GRBL it does not support the M6 commands
But I do know that if you can choose have it ignore errors, which it seems you did since it ran the 2nd time.

"failure is because GRBL doesn't support M6, In this case choosing Yes to skip the unsupported command is appropriate."
(from Winder--creator of UGCS)

And the guys reply
"On the other error I removed the "T1M6" from my post processor and no errors. Thanks for the help, I really appreciate it."

github.com/winder/Universal-G-Code-Sender/issues/603

[Derek the Admin]

It does this because it’s recognizing a tool change command in the code. It is trying to look out for you to make sure it doesn’t move into an operation that requires a different tool. In the UGS settings you can list M6 as an ignored command or “removed pattern”.

[cplymill]

Thank you for the quick response. Was in a hurry to test it and did not review the post process like I should have. I really appreciate it!!

[cplymill]

Oh yeah, any idea of the screw size I mention above?

[notso]

No idea, I have an M3 and use the spindle not router....sorry, have to wait for Derek on that one!

[Derek the Admin]

It's an M5