|
Post by ricko on Apr 8, 2018 21:16:15 GMT
Finally Complete after about 4 weeks of off and on effort. Powered right up and homed fine. Spoil boards not fastened yet. Getting ready to test. Any advice on the setup and use of the Z probe would be helpful.
|
|
|
Post by Bruce on Apr 9, 2018 14:58:17 GMT
Are you using UGS platform or something else?
|
|
|
Post by Derek the Admin on Apr 9, 2018 17:12:02 GMT
Couple things:
1) G38.2 Z-50 F100 would command a downward probe at 100 mm/min that will stop if it gets to Z-50 before making contact. Those probe parameters are good if you are in millimeters (G21) 2) We goofed on some of the boxes and had the probe base and probe clip wires switched. If you get an error immediately after issuing G38.2 Z-50 F100 then this probably applies to you. Luckily its a pretty easy fix that involves just swapping wires in the box. See the video below.
|
|
|
Post by ricko on Apr 9, 2018 17:21:45 GMT
Are you using UGS platform or something else? Using UGS
|
|
|
Post by ricko on Apr 9, 2018 20:18:40 GMT
Wire swap worked,used the Start Probe button in UGS.
|
|
|
Post by Derek the Admin on Apr 9, 2018 21:46:37 GMT
Excellent. Be sure to show us your projects,
Regards
|
|
|
Post by Bruce on Apr 10, 2018 13:29:15 GMT
Congrats on the Power Route build.
|
|
|
Post by VGCustomShop on Apr 18, 2018 19:25:58 GMT
Awesome build - great job!
|
|