rwatz
New Member
Posts: 9
|
Post by rwatz on Apr 8, 2018 22:53:41 GMT
Where is the best place to get New Uno boards and cnc shield Expansion boards plus the drv8825 stepper motor driver.
|
|
|
Post by Derek the Admin on Apr 9, 2018 1:17:03 GMT
I think we need to diagnose what you’ve got going on. If the drivers didn’t auto load then it’s not something that new boards would necessarily fix. It’s a pretty easy thing to do though to manually install the drivers.
|
|
rwatz
New Member
Posts: 9
|
Post by rwatz on Apr 9, 2018 1:46:42 GMT
well we were a little accident(smoke test) and burn up 2 of the driver. I would prefer to get new ones of everything to be on safe side. I will buy them since it was my mess up. Not knowing what all was damaged. I am not saying i still would not have to install it manually but just want to make sure everything is good
|
|
|
Post by brandonl on Apr 20, 2018 3:44:04 GMT
I had the same issues. What UNO Board do I need to buy and good source?
|
|
|
Post by Derek the Admin on Apr 20, 2018 13:11:55 GMT
What happened?
|
|
|
Post by brandonl on Apr 20, 2018 15:04:18 GMT
I pluged the power supply into the wrong board. So I need to replace the UNO board. Does that also require reloading any programming on the board?
|
|
|
Post by Derek the Admin on Apr 20, 2018 20:01:01 GMT
It does require that our particular version of Grbl be reloaded. Also, FYI, sometimes this also takes down the stepper drivers as well. Please PM us and we'll see to a low cost replacement for you.
|
|
|
Post by brandonl on Apr 23, 2018 22:07:05 GMT
Sent you a PM for above.
|
|