Carve King first tests

ken
New Member

Posts: 8

Carve King first tests May 19, 2018 23:25:03 GMT Bruce likes this

Quote

Derek,

Results of my first motion tests. I have the X and Y step size set to 420mm (16 1/2 in) and the Z step size at 90mm. The feed rate is set to 4400.

First I do a homing cycle then several jogs around the table in both directions and finish up with a final homing cycle. Good position and quiet.

I've put the X homing switch on the front side so I wouldn't have a bolt sticking out of the back to drag my arm on (personal preference).

BTW where is my PM for the parts I want to order?

Ken

Derek the Admin Administrator Posts: 4,084	Carve King first tests May 20, 2018 12:34:12 GMT via mobile Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by Derek the Admin on May 20, 2018 12:34:12 GMT Glad the test went well. I sent a pm and never got a response.
	MillRight CNC Staff I do not answer private messages. Please ask questions in public or hit up support@millrightcnc.com

ken New Member Posts: 8	Carve King first tests May 20, 2018 23:01:02 GMT Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by ken on May 20, 2018 23:01:02 GMT Derek, Where did you send the PM to? It didn't show up in my email. Ken

Derek the Admin Administrator Posts: 4,084	Carve King first tests May 21, 2018 4:46:10 GMT Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by Derek the Admin on May 21, 2018 4:46:10 GMT It should be in your inbox here in the forum. I just forwarded it back to you. Please let me know if you don't see it.
	MillRight CNC Staff I do not answer private messages. Please ask questions in public or hit up support@millrightcnc.com