|
Post by aquanub on Jul 1, 2018 22:57:35 GMT
Hello all!
As I am eagerly awaiting for the arrival of my power route, I am looking into getting a dust collection system up and running as well.
I've already ordered a cyclone dust separator and am actively on the hunt for a shopvac.
What are you guys using for a dust shoe / how are are you guys mounting them to the spindle? There isn't much available online for purchase yet, and I am not opposed to fabricating one either.
Thanks!
|
|
|
Post by Hommer Woods on Jul 1, 2018 23:16:40 GMT
|
|
|
Post by Hommer Woods on Jul 2, 2018 9:41:21 GMT
Also in this picture you can see my dust collector with the Dust Deputy and a cabinet that holds the shop vac. This reduces the noise from the vac. It is on wheels to make it easy to move around for various equipment in the shop and vacuuming the floor to clean up. Attachments:
|
|
|
Post by Hommer Woods on Jul 2, 2018 10:36:30 GMT
I also put two power strips on the dust collector so I have a fast way to turn the dust collector and router on and off at the same time while keeping power on to the PC, carve king and light continuously. Pics at the post below. millrightcnc.proboards.com/post/6216/thread
|
|
|
Post by aquanub on Jul 2, 2018 23:18:52 GMT
I also put two power strips on the dust collector so I have a fast way to turn the dust collector and router on and off at the same time while keeping power on to the PC, carve king and light continuously. Pics at the post below. millrightcnc.proboards.com/post/6216/threadHi Hommerwoods!
Thank you so much for sharing your awesome setup! I will definitely be borrowing some ideas
|
|