markj
New Member
Posts: 11 
|
Post by markj on Aug 5, 2018 3:29:49 GMT
Hello, this morning I tried to dial in X and Y axis from a excel document put out there from Derek. I entered in the values in UGS and it was set to inches and not millmeters. I am now having issues with the carveking homing and it gets a alarm at the end of the homing operation. So, now it does not matter if UGS is in inches or MM, seems to be just moving in millmeters. Has anyone experience this and how do you set things back. If anyone has any suggestions it would greatly be appreciated. Thanks!!
|
|
|
|
Post by Derek the Admin on Aug 5, 2018 4:24:30 GMT
Can you post all of your settings?
|
|
markj
New Member
Posts: 11
|
Post by markj on Aug 5, 2018 4:34:22 GMT
ok, for the 100mm by 100mm square
X was 99.88mm
Y was 100.41mm
I enter in UGS
$100=40.04
$101=39.83
|
|
|
|
Post by Derek the Admin on Aug 5, 2018 4:47:59 GMT
I’m not sure the exact resource you used but the issue here is that you are adjusting off the M3’s values from those settings instead of the Carve Kings.The M3 has 40 steps/mm for X and Y but the CK has 200. If you multiply your computed values by 5 I think you will be okay.
I’d encourage you to test that Y value a couple more times though and make sure the router is plum.
|
|
markj
New Member
Posts: 11
|
Post by markj on Aug 5, 2018 4:55:43 GMT
ok, Thanks Derek. I will try that and see if it corrects it.
|
|
