tim
New Member
Posts: 48
|
Post by tim on Aug 28, 2018 12:42:45 GMT
Both of my Dragchains just wouldn't turn into the correct position (upwards). instead, the only way to mount them with the screw - they would then turn downwards. After youtube videos i then realized, the end pieces of the Drag Chain can be pulled out and flipped. Then you can mount them and they will turn correctly.
I hope somebody who now uses google to get informations will find this thread!
|
|
|
Post by ibohan on Aug 28, 2018 20:21:51 GMT
I also ran into this. Took me a couple minutes of fiddling around trying to figure out how it worked.
Not to high jack the thread, but I also ran into an issue with the bolt-on chain support piece on the gantry. It seemed like the bolts were too long, and were bottoming out on the extrusion before the bracket was tightened down. I added some spacers under the bolt heads to engage the brackets.
|
|
tim
New Member
Posts: 48
|
Post by tim on Aug 29, 2018 2:01:29 GMT
Not to high jack the thread, but I also ran into an issue with the bolt-on chain support piece on the gantry. It seemed like the bolts were too long, and were bottoming out on the extrusion before the bracket was tightened down. I added some spacers under the bolt heads to engage the brackets. Didn't i posted about this yesterday? Seems like the Thread is deleted
|
|
|
Post by Derek the Admin on Aug 29, 2018 2:24:16 GMT
Only deleted one post recently and that was about spindle instructions that got handled with someone on email.
|
|