|
|
Post by aquanub on Sept 14, 2018 23:17:59 GMT
Hey guys Finally got my power route into its enclosure, I've reached the point where the instructions say to screw the drag chain into the back of the control box. I see the two holes in the box, but I dont see any holes on the drag link. Am I supposed to drill my own holes? Or am I missing a piece? 
Thanks!
|
|
|
|
Post by Derek the Admin on Sept 14, 2018 23:37:02 GMT
You should have a connector on the other side?
|
|
|
|
Post by aquanub on Sept 15, 2018 22:56:38 GMT
You should have a connector on the other side? the other side I have attached to the L bracket, but this side seems to not have anything? I went and looked at the photos of when I first unpacked it to see if a piece may have fell off, but it looks like its how it came.
 |
|
|
|
Post by Derek the Admin on Sept 16, 2018 0:01:46 GMT
Okay, we can send a connector piece.
|
|
|
|
Post by fyddler on Sept 17, 2018 14:01:54 GMT
I had the same issue, no connector piece.
I just drilled a couple holes and screwed it down to my table.
|
|
|
|
Post by Derek the Admin on Sept 17, 2018 14:27:51 GMT
Thanks for letting me know. I'll look into this more broadly.
|
|
|
|
Post by aquanub on Sept 17, 2018 18:07:34 GMT
Thanks for letting me know. I'll look into this more broadly. Would you like me to send you an email or how should I proceed? Thanks for investigating. |
|
|
|
Post by Derek the Admin on Sept 17, 2018 18:10:50 GMT
I already looked you up and have you on the list for tomorrows out mail.
Derek
|
|
|
|
Post by aquanub on Sept 21, 2018 0:41:37 GMT
I already looked you up and have you on the list for tomorrows out mail. Derek Got it today Derek, thank you for the speedy response! |
|
|
|
Post by Derek the Admin on Sept 21, 2018 1:40:46 GMT
Least I could do.
|
|
