|
Post by Big Man Black T-Shirt(Patrick) on Sept 30, 2018 10:12:22 GMT
Here are the Arduino's Grbl settings listed in the M3 User Manual. This is how your Arduino came preloaded from Millright CNC. If you've used Easel to send Gcode to your machine, then Easel overwrote your correct settings. My guess is once you change the settings back your issue will be solved. But when in doubt, don't trust me, ask Derek. $0=10 (step pulse, usec) $1=255 (step idle delay, msec) $2=0 (step port invert mask:00000000) $3=0 (dir port invert mask:00000000) $4=0 (step enable invert, bool) $5=0 (limit pins invert, bool) $6=0 (probe pin invert, bool) $10=3 (status report mask:00000011) $11=0.010 (junction deviation, mm) $12=0.002 (arc tolerance, mm) $13=0 (report inches, bool) $20=0 (soft limits, bool) $21=0 (hard limits, bool) $22=0 (homing cycle, bool) SETTING 22 SHOULD = 1 IF YOU HAVE HOMING SWITCHES, = 0 IF NOT $23=0 (homing dir invert mask:00000000) $24=25.000 (homing feed, mm/min) $25=600.000 (homing seek, mm/min) $26=244 (homing debounce, msec) $27=4.000 (homing pull-off, mm) $100=40.000 (x, step/mm) $101=40.000 (y, step/mm) $102=80.000 (z, step/mm) $110=8000.000 (x max rate, mm/min) $111=8000.000 (y max rate, mm/min) $112=3000.000 (z max rate, mm/min) $120=250.000 (x accel, mm/sec^2) $121=250.000 (y accel, mm/sec^2) $122=250.000 (z accel, mm/sec^2) $130=264.000 (x max travel, mm) $131=264.000 (y max travel, mm) $132=69.000 (z max travel, mm)
|
|
|
Post by Derek the Admin on Sept 30, 2018 18:19:32 GMT
Thanks Patrick.
|
|