|
|
Post by Hommer Woods on Oct 6, 2018 19:39:49 GMT
I am having a small issue with a pocket for an inlay. When it cuts I get a small entry point in the upper right corner. That is not the initial entry point but in the middle of the job. Any suggestions? Attachments:
|
|
|
|
Post by ibohan on Oct 7, 2018 2:36:21 GMT
If you're using Fusion 360, try adjusting the Lead-In and Lead-out options:  But I think this is a little buggy. I've tried adjusting these in the past and sometimes it made the lead-ins bigger when I set them to be smaller. |
|
|
|
Post by Derek the Admin on Oct 7, 2018 11:21:55 GMT
I too think it’s a lead in and lead out issue. I’ve unfortunately been bitten by this a time or too myself.
|
|
|
|
Post by Hommer Woods on Oct 7, 2018 13:45:56 GMT
I am using Cut2D and don't see those settings anywhere. However I changed the cut from Raster to Offset for the inlay pocket and the issue is gone. Attachments:
|
|
