I don't see the settings in the latest edition of the M3 assembly manual. (Derek, shouldn't this be added to the manual?)
I found the M3 GRBL settings in a post by Patrick. I assume these are correct.
$0=10 (step pulse, usec)
$1=255 (step idle delay, msec)
$2=0 (step port invert mask:00000000)
$3=0 (dir port invert mask:00000000)
$4=0 (step enable invert, bool)
$5=0 (limit pins invert, bool)
$6=0 (probe pin invert, bool)
$10=3 (status report mask:00000011)
$11=0.010 (junction deviation, mm)
$12=0.002 (arc tolerance, mm)
$13=0 (report inches, bool)
$20=0 (soft limits, bool)
$21=0 (hard limits, bool)
$22=0 (homing cycle, bool) SETTING 22 SHOULD = 1 IF YOU HAVE HOMING SWITCHES, = 0 IF NOT
$23=0 (homing dir invert mask:00000000)
$24=25.000 (homing feed, mm/min)
$25=600.000 (homing seek, mm/min)
$26=244 (homing debounce, msec)
$27=4.000 (homing pull-off, mm)
$100=40.000 (x, step/mm)
$101=40.000 (y, step/mm)
$102=80.000 (z, step/mm)
$110=8000.000 (x max rate, mm/min)
$111=8000.000 (y max rate, mm/min)
$112=3000.000 (z max rate, mm/min)
$120=250.000 (x accel, mm/sec^2)
$121=250.000 (y accel, mm/sec^2)
$122=250.000 (z accel, mm/sec^2)
$130=264.000 (x max travel, mm)
$131=264.000 (y max travel, mm)
$132=69.000 (z max travel, mm)
