ian
New Member
Posts: 4
|
Post by ian on Oct 29, 2018 19:57:26 GMT
Hello, in setting up my carve king. I'm at the stage for testing the motors. I have downloaded g code sender software for Mac. All appears normal, but when I press any of the axis buttons I get no movement from any motors. I'm wondering if I may have messed up the UNO board. I had previously download blinking light code from arduino site to test Uno board. I did reset board to clear blinking light code. Wondering if this may be effecting G code sender communicating with the board now. Do I need a new UNO board? Any help would be appreciated. Thanks.
|
|
|
Post by Derek the Admin on Oct 29, 2018 22:09:29 GMT
You may not have messed up the board, but you did overwrite the firmware on it when you loaded the blink test from the Arduino IDE. I will post the firmware for you when I get to the office tomorrow or later tonight if I can get to my laptop.
Derek
|
|
ian
New Member
Posts: 4
|
Post by ian on Oct 30, 2018 12:15:28 GMT
Thank you very much for helping me with this.
|
|
|
Post by Derek the Admin on Oct 30, 2018 14:14:30 GMT
|
|