kerry
New Member
Posts: 4
|
Post by kerry on Nov 18, 2018 23:12:45 GMT
Finally got around to adding the Jtech to my Carve King this weekend. Finished all the assembly, moved Z Homing switch to SP EN, plugged in the Signal cable to Z+. couple of issues. Here's screen output below First, the M3 S3500 doesn't turn on the laser. Was going to do the focus step. I did double check the the switch was on TTL and I can get the laser to turn on manually via this switch. Second is that $H doesn't go back to home any longer. Z moves down about 1mm and that's it. Also get an 'ALARM:8' when trying a $H. I did NOT flash the board per the instructions because I did order the CC and Laser at the same time, so assuming it's all good there. just need a couple suggestions to check. Thanks in advance.
$0=10
$1=255
$2=0
$3=0
$4=0
$5=0
$6=0
$10=1
$11=0.010
$12=0.002
$13=0
$20=0
$21=0
$22=1
$23=0
$24=35.000
$25=1200.000
$26=94
$27=4.000
$30=12000
$31=0
$32=0
$100=200.000
$101=200.000
$102=200.000
$110=3500.000
$111=4400.000
$112=3000.000
$120=240.000
$121=240.000
$122=240.000
$130=432.000
$131=432.000
$132=95.000
ok
>>> g1 f300
ok
>>> m3 s3500
ok
>>> $32=1
error:5
|
|
|
Post by Bruce on Nov 19, 2018 2:30:13 GMT
Check with Derek on issues with laser.
|
|
|
Post by Derek the Admin on Nov 19, 2018 3:14:38 GMT
Let's make sure that we actually have the laser firmware on there. See the attached for the laser firmware. Also, here is what Grbl documentation for Alarm 8: Homing fail. Cycle failed to clear limit switch when pulling off. Try increasing pull-off setting or check wiring. It's like it's triggered from the onset. I bet you need that firmware. Carve King Homing and No Homing Laser Spindle.hex (83.76 KB)
|
|
kerry
New Member
Posts: 4
|
Post by kerry on Nov 19, 2018 12:38:26 GMT
Thanks Derek, I'll pull it down today and check.
|
|
kerry
New Member
Posts: 4
|
Post by kerry on Nov 19, 2018 16:22:14 GMT
Perfect! that did the trick! Thanks!
|
|
|
Post by Derek the Admin on Nov 19, 2018 18:19:38 GMT
Awesome. Sorry for the issue.
|
|
|
Post by cncnoob on May 19, 2020 0:27:47 GMT
I'm having the same issue except it still homes just fine. Same scenario as above except with the Mega V instead of the Carve King. The only link I see for the firmware says it's for the carve king; Will that work for the Mega V as well?
|
|
|
Post by Bruce on May 23, 2020 4:34:25 GMT
Check the Millright breakout board. I think you just connect to the PWM signal for the laser level control. And then turn it on in the GRBL setup. $32=1 Laser mode enable
|
|