Post by thejollyllama on Feb 16, 2019 22:03:27 GMT
Hey everyone,
I'm about half way through the Carve King assembly and just finished putting the frame together and I think I've hit a bit of a snag. When I push the gantry to the back of the frame, the Y axis plates do not touch at the same time, so I'm guessing there must be a skew somewhere in the frame. I tried pulling the rear piece of MDF in with the corner brackets and ensuring there was a 1/64" (measured w/ a feeler gauge) gap per the manual, but it hasn't helped in squaring up the frame. Does anyone know how to go about troubleshooting this issue or will a later step in the process pull everything into square? Any help would be much appreciated!
Attaching a video to demonstrate the issue: photos.app.goo.gl/VTHs3zTaKpJi82sc7
I'm about half way through the Carve King assembly and just finished putting the frame together and I think I've hit a bit of a snag. When I push the gantry to the back of the frame, the Y axis plates do not touch at the same time, so I'm guessing there must be a skew somewhere in the frame. I tried pulling the rear piece of MDF in with the corner brackets and ensuring there was a 1/64" (measured w/ a feeler gauge) gap per the manual, but it hasn't helped in squaring up the frame. Does anyone know how to go about troubleshooting this issue or will a later step in the process pull everything into square? Any help would be much appreciated!
Attaching a video to demonstrate the issue: photos.app.goo.gl/VTHs3zTaKpJi82sc7
