|
|
Post by mrbigj on Mar 12, 2017 5:33:42 GMT
Anyone using Vectric Cut3d? I am testing it during the trial period. When I got to save the toolpaths, GRBL is not one of the options. What do I save it in? There's only about 100 options and none of them say anything about GRBL...
Jason
|
|
n9xwp
New Member
Posts: 9 
|
Post by n9xwp on Mar 12, 2017 9:56:20 GMT
Do you know where on your hard drive the PP are stored?
|
|
|
|
Post by mrbigj on Mar 12, 2017 15:41:20 GMT
Do you know where on your hard drive the PP are stored? PP? |
|
|
|
Post by Derek the Admin on Mar 13, 2017 1:06:58 GMT
Post processor.
Might want to contact Vetric and see what they recommend.
I could have sworn they had a grbl post. I'd look for a generic post processor if they have one listed while you wait to hear back from Vetric.
You can load the g code file into UGS and set Grbl to check mode with $C then send the file. It won't move anything while in check mode, but will report errors in the code for anything not valid.
|
|
|
|
Post by aforww on Mar 13, 2017 10:55:03 GMT
I gave it a look. Looks like you can use the "DesktopCNC Gcode" option with a .dnc extension. UGS will open it.
|
|
|
|
Post by mrbigj on Mar 13, 2017 11:48:12 GMT
I gave it a look. Looks like you can use the "DesktopCNC Gcode" option with a .dnc extension. UGS will open it. Thanks. I will give that a try after work tonight. J |
|
davel
New Member
Posts: 8
|
Post by davel on Mar 14, 2017 18:11:34 GMT
I am using Vectric Vcarve desktop. I am using the G Code Inch (*.tap) Post Processor. You have to set UGS to inches and then jog it a bit first because I read it ignores the set to inches instruction.
|
|
|
|
Post by Big Man Black T-Shirt(Patrick) on Feb 12, 2018 0:38:03 GMT
I'm trying to run code from Vectric Aspire and I keep getting errors also.
I've tried each of these to no avail.
Grbl mm .gcode throws error
X-Carve mm .gcode throws error
DeskCNC Gcode mm .dnc throws error
G Code mm .tap throws error
Ideas?
|
|
|
|
Post by Derek the Admin on Feb 12, 2018 3:39:53 GMT
What errors is it throwing?
|
|
