shawn
New Member
Posts: 3
|
Post by shawn on Nov 8, 2019 15:42:04 GMT
I just got my first Carve King assembled. Haven’t even fired it up yet, need to build a table/bench for its permanent location in the shop. My shop is mostly unheated, however I do have a small clean room that is heated that I use for gluing etc in the winters. I would prefer not to use the heated area because of space restrictions, the unheated area temperatures average 40 degrees in the winters but at times could get a little lower. Will this be a problem for the electronics or wheels etc.?
|
|
|
Post by Derek the Admin on Nov 8, 2019 18:14:10 GMT
It will be just fine.
|
|
shawn
New Member
Posts: 3
|
Post by shawn on Nov 9, 2019 13:58:11 GMT
Ok thanks, good to know
|
|