|
Post by johnnyzapata on Apr 24, 2017 5:17:40 GMT
New here so if this has been answered I couldn't find it and I apologize. I'm not sure how to wire these homing switches or where they go exactly. Any help here would be greatly appreciated.
|
|
|
Post by Derek the Admin on Apr 24, 2017 13:40:11 GMT
Do you still have the single page sheet that covers homing switch wiring? Black to COM, red to NO, then the "limit switch" section of the board has that. Red wire to the left, black wire to the right.
I think you have a laser. Lasers require us to change a limit pin so you will want to look at the laser set-up instructions too... but basically you will plugn in the Z switch wires to "Sp En" on the board and plug in thr laser signal line (the red and black wires with the 2 point female connector) into "Z limit". That sounds odd but I typed it right. Check out the homing wiring sheet for the nitty gritty details. The above is just a little exception for your situation with the laser.
|
|