|
Post by brewvet on May 10, 2020 21:34:33 GMT
Finally got the Mega V assembled and while testing it, noticed the router had some vertical play when cutting. Sure enough one of the two mounting screws worked its way loose. Question is how do I tighten this?
|
|
|
Post by garymkrieg on May 10, 2020 22:00:58 GMT
Remove the Z plate from the rails and tighten, I'm sure that's not what you wanted to hear.
|
|
|
Post by brewvet on May 10, 2020 22:11:23 GMT
Remove the Z plate from the rails and tighten, I'm sure that's not what you wanted to hear. That's what I was thinking, but worried the bearings might come out, the other issue is two of the screws are partially blocked by the router bracket.
|
|
|
Post by brewvet on May 10, 2020 23:33:11 GMT
Ok, worst fear realized after loosening all the screws and lowering the plate about 1/2 dozen of the ball bearings came out on one of the assemblies.
|
|