|
Post by greatgrizzly on Jun 18, 2020 13:36:59 GMT
Im new to cnc and I am late to finishing up my mega v xl (I kick started). I was about install my motors when I noticed that the wheels were touching on one side (the left) when bring it it all the way forward. But not the other. All my parts seem straight, so I am assuming something is out of square, but I am not sure how to correct that. Has anyone else run into this and have any advice?
I can get some photos later if that would help. Thanks!
|
|
|
Post by Bruce on Jun 23, 2020 3:39:22 GMT
|
|