mike9
New Member
Posts: 5
|
Post by mike9 on Jul 22, 2020 13:23:16 GMT
One if my new motors of the cnc m3 is slipping when i try to move. i think it broken.
Can i buy any new nema motor or must it be a special one?
Our better yet by another type?
Please help/
Kind regards,
Mike
|
|
|
|
Post by joebob296 on Jul 23, 2020 2:39:35 GMT
Is it new directly from millwright? If so I would email them. Replace with same model to. You don't need a different type, same motor = same driver.
|
|
|
|
Post by kevin on Jul 23, 2020 3:00:27 GMT
Can't say it couldn't be a motor, but of all the items in the movement chain, (motors, boards, drivers, couplers) the motors are usually the least likely to fail. If you haven't checked the coupler to see if it's slipping I'd start there. If the coupler is good and tight with no slippage, the next suspect would be a driver. If you haven't already done so, you can swap where the problem motor is plugged in with one of your other motors that is working properly to see if it continues to have issues or if it now works properly and the other motor is now problematic. If that happens it's most likely a bad driver or incorrect driver settings.
|
|
mike9
New Member
Posts: 5
|
Post by mike9 on Jul 23, 2020 8:23:38 GMT
I have change te motor to another driver and the same result. So it isn’t the driver, i also checked the coupler and its good.
So what nog? I would-be like to use the machine asap
|
|
|
|
Post by kevin on Jul 23, 2020 10:54:08 GMT
Send an email to support@millrightcnc.com and let them know what you've got going on and the steps you've taken to determine the issue isn't a loose coupler or bad driver.
|
|
|
|
Post by joebob296 on Jul 25, 2020 23:42:36 GMT
I have change te motor to another driver and the same result. So it isn’t the driver, i also checked the coupler and its good. So what nog? I would-be like to use the machine asap If its not the driver and the motor, swap the motor to a working driver and test. Do the same for the motor.
|
|
|
|
Post by Bruce on Aug 1, 2020 21:27:40 GMT
Mike9, did you get your problem resolved?
|
|
