James
New Member
Posts: 11 
|
Post by James on Jul 10, 2017 9:40:44 GMT
I noticed you mentioned Easel in the post above. I am having an issue when I send the work to my machine it will not send. I manually select the COM port and nothing happens. I was successful at making my first cuts with some g-code from the quick start guide in the resources tab and was very happy with the results.
|
|
|
|
Post by aforww on Jul 12, 2017 1:21:59 GMT
I am pretty sure this was answered already, I just moved the question to General Discussion. Delete if no longer needed and answer is elsewhere for people.
|
|
James
New Member
Posts: 11
|
Post by James on Jul 12, 2017 2:26:25 GMT
Yes I did get an answer. Going to advance and saving the G-code then I used the g-code in Universal G-code sender to cut.
|
|
|
|
Post by activereality on Jul 13, 2017 13:37:14 GMT
James,
Thank you for sharing. I was looking at easel (to spread my wings a bit and not be dependent on one program) and found similar issues to trying to get g-code from easel. Since i don;t even have a machine hooked up, it was even a bit more frustrating- cause it should be easier right!? haha. So this has already helped!
Aaron
|
|
