|
|
Post by Hommer Woods on Jul 13, 2017 1:37:13 GMT
I purchased the machine to do inlay and etching work. First couple of projects turned out good. Will be a huge asset in my woodworking tool set. |
|
|
|
Post by breslinmr on Jul 13, 2017 2:13:27 GMT
Looking good. Had too beat the celtic sign lol.
|
|
|
|
Post by Derek the Admin on Jul 13, 2017 12:00:12 GMT
Looks good. What was your workflow on the inlay?
Mind if I give a pointer to this thread on social media?
|
|
|
|
Post by Hommer Woods on Jul 14, 2017 2:12:47 GMT
You can link to it on social media. For the top picture I routed out a 1/8 deep pocket in a 1/4 piece of Mahogany and cut the parts in the bottom photo from a 1/8 piece of Maple. Didn't require much clean up to get them to fit.
The middle photo was done by gluing a 1/16 piece of Walnut on a 1/4 piece of Oak and just routing out the design 1/8 deep.
I used Corel Draw to create svg files that I then imported into Easel to get the gcode.
I create wooden boxes that are 10 x 5 and these will be the tops.
|
|
|
|
Post by kevin on Jul 14, 2017 3:26:03 GMT
That's good looking work.
|
|
|
|
Post by Derek the Admin on Jul 14, 2017 3:41:29 GMT
Thanks. I'll share it.
|
|
