|
Post by jeisenman on Sept 26, 2021 1:37:48 GMT
Trying to make my first cut, my machine backed up against the y limit switch, now it's stuck there..UGS shows it being tripped/engaged. I can also see that my x track is pushing against my y limit switch. What do I do? Carve King 2, UGS, fusion
|
|
Fink
New Member
Posts: 7
Location: Houston, TX
Machine: Other
|
Post by Fink on Sept 28, 2021 19:20:59 GMT
I am fairly new to all of this but I have experienced the same issues you have and below is what I did.
If you have limit switches the first thing you should do when powering on the controller and connecting with UGS is to Home the machine. This is not a requirement but is good practice and you might as well since you went through the effort of installing the limit switches. If at any point you trigger a home switch after homing the machine you will need to unlock UGS by going to Machine --> Actions --> Unlock and you should be able to move the machine again.
Since I do not have the 4th axis option I now use OpenBuilds vs UGS and I find it to be easier.
|
|