|
Post by kec-10238 on Jul 18, 2017 3:11:01 GMT
Have to do anything special for xp 32 bit O/S set-up? Anyone using Vcarve pro?
|
|
|
Post by kec-10238 on Jul 18, 2017 20:17:50 GMT
Tried Fusion360 - no go need a 64bit operating system, Same as artcam so playing with v-carve pro - looks easy enough - runs under xp. Plenty of learning time before machine arrives.
|
|
|
Post by Derek the Admin on Jul 19, 2017 3:45:02 GMT
Ya, 32 bit won't run Fusion. Glad you've got v-carve though. By the way... if case you are still in any kind of trial period with V Carve, you might want to look at V Carve Desktop. I'm not totally familiar with Vectric products, but I think the desktop version is much like the pro version but it's just limited to a smaller model size. If I remember correctly, that limit is a decent bit bigger than the CK work area. Just something to look into maybe because the desktop version is a lot cheaper than the pro version.
|
|
|
Post by kec-10238 on Jul 19, 2017 18:30:19 GMT
yes but I have a 4x8 machine coming in september/October so I just plan on using the regular version. I see the s/w also has the (mm/inch) GRBL post-processor as 1 of it's choices as well as some other smaller unit machines you can choose that use similar controllers.
|
|
|
Post by Derek the Admin on Jul 19, 2017 19:40:01 GMT
Yup. You know Grbl's the real deal when all the big software companies start righting posts for it.
|
|