gari
New Member
Posts: 6
|
Post by gari on Sept 26, 2022 0:44:15 GMT
Hello All,
I have been making some signs in the last few weeks and things have been going great. I have the Carve King 1. On my last few signs, I had a missed step that caused it to ruin the sign. Not a huge deal but still sucks. I had previously put alignment lines on my rods and couplers and there was no slippage. So I started another sign and all was good until I did the profile cut to cut out the sign. It started it and when around half of the sign and then it stopped. Nothing in UGS worked so I logged out and logged back in. I jogged the Y, worked...jogged the X, worked...jogged the Z...nothing. There were codes that scrolled after my x and y jogs, but nothing after my z jogs. It just went dead and nothing works any more. Someone on Facebook group suggested I try open builds. I downloaded that and connected it to machine and x jogged fine, y jogged fine and then z...same thing happened. Now openbuilds says that there is an error,no supported firmware detected. I assume that there is a connection problem with Z motor, but thought I would ask before I start ripping things apart. Much appreciated.
|
|