Post by transientmole on Mar 7, 2023 4:17:02 GMT
A few suggestions - make sure that the $30 value in your controller firmware settings (Edit|Machine Settings|$30) match what is in Lightburn's Device settings (Edit | Device Settings | Max S-Value), as thats how lightburn calculates the value<->percentage of power. Then make sure on the fire box, the power isnt set too low or the beam may not fire. Start with like 5-10% (Which should always fire it) then back it down to the lowest value you see....
The newer versions of MR firmware set the $30 value to like 100, where the old ones were 1000, or 12000. Its very likely your lightburn device settings is just out of sync with what the firmware has now...
The newer versions of MR firmware set the $30 value to like 100, where the old ones were 1000, or 12000. Its very likely your lightburn device settings is just out of sync with what the firmware has now...