Dust boot hose

[robertl]

Looking for suggestions or ideas on where/how to put the hose for the dust boot to keep it out of the way while the machine is cutting.  I have the XL and it sits on a table that is two inches wider than the frame rails and about six inches deeper if that helps you visualize my set up.  Also do you run the router power cord along with this hose or are you all running it through the chain drags? My control box is on the outer left on a shelf and under the table is completely clear.  I figure I will put the dust collector under there.  For now the dust collector will just be a shop vac.  Pictures of your set up would be great.  Thanks  

[bLouChip]

If you have an old fishing pole, you can do this...

drive.google.com/open?id=1L0lFrhj59W-XnCqOfYzUAyfHVmCzfOcx

more pics here:

drive.google.com/drive/folders/1Kqt8RInPSwdsv4s-5aUB3uAAHuvQLFic

Putting the router power cord in the drag chain could induce EMI/RFI onto CNC signal lines, not a good idea, makes for erratic CNC operation.

[robertl]

Thank you very much bLouChip. I didn't give thought to the radio interference