Pre-Machine Testing Mode with VCARVE and UGS

[kec-10238]

So without a machine yet, have been playing with VCARVE PRO Trial version since that is what I will probably end up using. Took one of their sample designs and ran it thru their GRBL post processor and saved the gcode text to a text file. At this point I am not sure if I would be able to send the post processed gcode directly to the machine or save the gcode text file as I have then run it through the universal gcode sender to the machine. In any event, the gcode produced by VCARVE was able to be visualized with the universal gcode sender. Not sure what any setting should be so far but it's nice to know it seems to work so far. I have attached the VCARVE sample code as a text file for anyone interested.



vcarve sample.txt (113.29 KB)

[Derek the Admin]

Looks like that would be good code. There's nothing off-the-wall about it. IT looks like you'll be ready to hit the ground running.

[kec-10238]

awesome