Mega V - Gcode Sending Errors

[dabcustoms]

Hello,
I have a mega v full sheet. Every time I go to run a leveling program, I always run into issues with the machine stopping. Normally it just stops, just says idle and doesn't give me any feedback in the console section.
Today I had these same issues however I also got a status showing sleep. Here is the code I received in the console section and what it said once I cancelled the job and entered $.


>>> G1X27.6807Y73.6807

Grbl 1.1h MegaV 3axisv1 ['$' for help]



**** Canceling file transfer. ****



>>> $

[HLP:$$ $# $G $I $N $x=val $Nx=line $J=line $SLP $C $X $H ~ ! ? ctrl-x]


This machine gets to be REAL frustrating. I have been able to do plenty of small things on this full sheet machine, however I have never been able to do anything full sheet.... NOTHING! Even just trying to level the spoilboard has never worked.

Does anyone have any insight?

**Edit**
I just received this code....
>>> G1Y75.2450

[Error] An error was detected while sending 'G1Y22.5150': (ALARM:0) An unknown error has occurred. Streaming has been paused.

>>> G1X21.7550

And the status reads DOOR

Thanks!

[keelhaulin]

Hopefully you have had better luck since. But if not, try plugging the router into a different circuit.

I think the router causes just enough noise in the AC circuit to interrupt usb communication between the computer and the cnc machine.

I used to have the same problem with jobs stopping at random times and having to restart the job or edit the gcode to start near where the job stopped.

Since plugging the router in somewhere else I have not had issues.