|
Post by breslinmr on Jul 27, 2017 1:04:16 GMT
What are these for see nothing on instructions about them
|
|
|
Post by deepdivetc on Jul 27, 2017 1:18:56 GMT
Those are Heat sinks that can go on the stepper chips. Derek told me that if the fan is installed on the control box and blowing over the chips that they are not needed.
|
|
|
Post by jkendall on Jul 27, 2017 15:04:59 GMT
They go on the little chip things on your stepper driver. Without them you would be replacing electronics often.
|
|
|
Post by breslinmr on Jul 27, 2017 17:11:28 GMT
They go on the little chip things on your stepper driver. Without them you would be replacing electronics often. oh ok so maybe ill put them on lol. doesn't show anything on instructions so they just stick on the top of the chip as you look down onto the board
|
|
|
Post by aforww on Jul 27, 2017 17:17:11 GMT
Use a bit of thermal paste to attach em to the drivers and away you go. You don't really need them if you do moderate milling times and have the fan mounted over the board. I put em on because I live in S. Texas and it's hells heater down here.
|
|
|
Post by breslinmr on Jul 27, 2017 17:24:40 GMT
Use a bit of thermal paste to attach em to the drivers and away you go. You don't really need them if you do moderate milling times and have the fan mounted over the board. I put em on because I live in S. Texas and it's hells heater down here. Thermal Paste lol never heard off it can i not just peel sticky tape off the back off them lol
|
|
|
Post by aforww on Jul 27, 2017 17:25:58 GMT
Lol you can. However, I just go for maximum effectiveness.
|
|