|
Post by Hommer Woods on Jul 28, 2017 1:16:34 GMT
|
|
|
Post by breslinmr on Jul 28, 2017 1:28:51 GMT
I've seen a few videos about taping work down personally haven't had the chance to try it yet. But seems to be a mixed reviews out there about this technique. I will give it a try in the near future what harm could it do as they say lol
|
|
|
Post by Derek the Admin on Jul 28, 2017 1:58:55 GMT
I can't load the vid here at the house, but I think I've seen that one.
You guys should also look into a vacuum pad. I just bought a vac pad and venturi tube for about $140. Works like a charm. It's only 8x8 but it has some serious hold down power.
|
|
|
Post by deepdivetc on Jul 28, 2017 2:19:33 GMT
Derek, do you have a link to one, I would like to look into that some
|
|
|
Post by Derek the Admin on Jul 28, 2017 16:14:31 GMT
|
|
|
Post by billb0169 on Jul 28, 2017 19:26:40 GMT
Hi Derek, Just wondering if you got a special deal? I'm seeing $430 for the vacuum pad on their site. Maybe I'm looking at the wrong item though.
|
|
|
Post by Derek the Admin on Jul 28, 2017 19:30:55 GMT
Look at "vacuum table"... I should have said "table" instead of pad. The R series is very affordable for what it is.
|
|
|
Post by aforww on Jul 29, 2017 1:30:54 GMT
I use this tape method all the time. Super quick and easy. I even used it milling that 1/2" aluminum.
|
|
|
Post by aforww on Jul 29, 2017 2:16:44 GMT
Look at "vacuum table"... I should have said "table" instead of pad. The R series is very affordable for what it is. I was going to make one but this so cheap in comparison, I will let them do the work.
|
|
|
Post by Derek the Admin on Jul 29, 2017 3:58:20 GMT
My thoughts exactly.
|
|
|
Post by breslinmr on Jul 29, 2017 17:20:01 GMT
Derek im sure you have plenty of time on your hands lol you could make them
|
|