|
Post by richard432 on Aug 6, 2017 18:53:44 GMT
i would like to know if there is a collets that would screw on a spindle i think I've have a 10 mmx14 thread spindle head
thank you
Richard Westerfield
|
|
|
Post by aforww on Aug 6, 2017 19:02:01 GMT
i would like to know if there is a collets that would screw on a spindle i think I've have a 10 mmx14 thread spindle head thank you Richard Westerfield Which spindle are you using?
|
|
|
Post by richard432 on Aug 6, 2017 22:31:39 GMT
i am using a Ryobi but could change router to fit the collets i am looking for a 1/2 collets
thank you Richard Westerfield
|
|
|
Post by aforww on Aug 6, 2017 22:41:07 GMT
Ah ok. Probably not. If your router didn't come with a 1/2" collet you're not going to find one. That's usually reserved for the heavier routers.
Curious, why are you looking for 1/2"?
|
|
|
Post by richard432 on Aug 6, 2017 23:07:42 GMT
thinking about making a small lathe that could turn 1/2 inch stock
|
|
|
Post by aforww on Aug 6, 2017 23:24:39 GMT
And you want to use a router to turn the stock?
|
|
|
Post by richard432 on Aug 7, 2017 0:09:26 GMT
after thinking about this a little this is not a good idea back to the drawing board
|
|
|
Post by breslinmr on Aug 8, 2017 6:22:27 GMT
Anyone now where to get 1/8 collet for Bosch colt that's not a rediculous price they seem to be expensive. Or has anybody tried 1/4 to 1/8 adapters are they any good ??
|
|
|
Post by Hommer Woods on Aug 8, 2017 11:18:35 GMT
I purchased the 1/4 to 1/8 adapter and some of the bits at the link below and they work fine in my Dewalt. inlaybanding.com/misc.html
|
|
|
Post by richard432 on Aug 8, 2017 14:12:25 GMT
I purchased the 1/4 to 1/8 adapter and some of the bits at the link below and they work fine in my Dewalt. inlaybanding.com/misc.htmlthanks for the information
|
|