|
Post by icarii on Aug 9, 2017 0:11:26 GMT
I got the machine together and successfully ran the test file from the quick start guide with no problems. Only material I had was an uneven hunk of some foam from my wife's arts and crafts supply. But I am happy I got it to work correctly without a lot of troubleshooting. Next I am going to work on Fusion 360 and getting some actually material that I can run through the machine. Attachment Deleted
|
|
|
Post by aforww on Aug 9, 2017 2:18:04 GMT
That's actually a pretty good idea for a first run. Foam is pretty forgiving.
|
|
|
Post by breslinmr on Aug 9, 2017 2:20:40 GMT
well done good job. i was the same just using bits off scrap around garage
|
|