|
|
Post by elevatedgrain716 on Aug 18, 2017 23:52:03 GMT
Hey guys just had an issue after running the same file multiple times.
Loaded up the nc file and realized my x axis nema is now running in the opposite direction. Confirmed in g code sender that x+ and x- are reveresed .
Not sure what could have happened as I ran the file multiple times so I know it should run fine. Any suggestions or advice on what I may have done?
|
|
|
|
Post by aforww on Aug 19, 2017 0:10:01 GMT
Well if you've run it without issue before, are you using Easel? Maybe it changed something. Have you edited the design and maybe flipped the axis? Type $$ into ugs. $3 should be $3=O.
|
|
|
|
Post by elevatedgrain716 on Aug 19, 2017 0:22:52 GMT
I am using easel and just now saw that it is using Grbl 1.1f. I am pretty sure prior it was grbl 09 It seems that changed the code from what I had saved previously .
SOLVED: reloaded the grbl9 hex file to the uno and all is right with the world. Seems easel had a firmware update that I missed and yes was clicked.
|
|
|
|
Post by aforww on Aug 19, 2017 2:13:38 GMT
I am using easel and just now saw that it is using Grbl 1.1f. I am pretty sure prior it was grbl 09 It seems that changed the code from what I had saved previously . SOLVED: reloaded the grbl9 hex file to the uno and all is right with the world. Seems easel had a firmware update that I missed and yes was clicked. Lol well feel free to use GRBL 1.1f Just copy and the values for your current .hex and transfer em over when you update. If you ever want to do probing, auto leveling, or the work flow helper, you'll have to do it eventually. |
|
|
|
Post by elevatedgrain716 on Aug 19, 2017 12:56:15 GMT
I am using easel and just now saw that it is using Grbl 1.1f. I am pretty sure prior it was grbl 09 It seems that changed the code from what I had saved previously . SOLVED: reloaded the grbl9 hex file to the uno and all is right with the world. Seems easel had a firmware update that I missed and yes was clicked. Lol well feel free to use GRBL 1.1f Just copy and the values for your current .hex and transfer em over when you update. If you ever want to do probing, auto leveling, or the work flow helper, you'll have to do it eventually. Thanks aforww. After I get through these operations maybe I'll give that a whirl. |
|
