|
Post by bwerner22 on Aug 19, 2017 18:17:03 GMT
Derek,
I love my M3! Recently one of the stepper driver's stopped working. The I checked x, y and z and found that z is the problem. It will not rise when I click z+ in universal g code sender. Also, I can raise and lower it by hand. I switched the x stepper driver with the z driver and found that it works. So I also checked the Y stepper driver to make sure it's not the board. I tried replacing it with the extra one in the kit but it no longer makes 1mm steps, it seems like an inch or so that it moves up and down abruptly. How do I correct this?
|
|
|
Post by Derek the Admin on Aug 19, 2017 19:26:35 GMT
Hey. Can you give a screenshot or a copy and paste of your $$ settings please?
|
|
|
Post by bwerner22 on Aug 19, 2017 20:19:30 GMT
|
|
|
Post by bwerner22 on Aug 24, 2017 1:44:09 GMT
Bump
|
|
|
Post by aforww on Aug 24, 2017 2:46:54 GMT
Oh crap man. This never got addressed. When you replaced the driver did you remove the jumpers? And to clarify, the replacement worked for movement, now you just gotta get distance corrected?
|
|
|
Post by Derek the Admin on Aug 24, 2017 2:57:49 GMT
Yes, please accept my personal apologies that this didn't get addressed after you posted those settings. I'm also curious if any jumpers were removed.
If not, I'd like to examine your board. You're technically out of the warranty period, but I'll happily trade you a new set of boards for that set of boards as I'd like to examine them and get you back running soon. Let us know about that jumper though. If not, PM me your address and I'll reply with our shop address.
|
|
|
Post by bwerner22 on Aug 25, 2017 1:18:33 GMT
Hi Derek, no problem! I imagine keeping up with the message board takes a lot of time. Yes I replaced the jumpers but the movements are more than 1 mm movements on one one axis. I appreciate you shipping me a new board but I can honestly purchase it from you if I'm out of warranty.
|
|
|
Post by aforww on Aug 25, 2017 1:29:26 GMT
Are the jumpers placed the same location for all three?
|
|
|
Post by Derek the Admin on Aug 25, 2017 1:30:16 GMT
There's a value to me in examining the board that you have which is why I just want to trade ya. I want to look at and pinpoint the issue for future reference. If the shipping thing it to me proposition is a hassle on your end, we could just sell ya replacements very reasonably. Either offer is on the table. Just PM me.
Thanks
|
|