bfran
New Member
Posts: 1
|
Post by bfran on Aug 20, 2017 14:22:21 GMT
I have been building my M3 for two weeks now...Very slowly to make sure I am doing it right...Have had to make several course corrections but generally I think I'm close. Now installing the UNO board and the covering step motor board. I have been trying to adjust the "pots" for two days. Purchased a multimeter. Think I am using it properly after several false starts. I am getting a 24.6 reading at the blue port.I am getting nothing at any of the pots....I did have a slip on the X board which caused a spark....Changed to the fourth supplied board...Still does no read....HELP?
|
|
|
Post by Derek the Admin on Aug 21, 2017 1:31:59 GMT
Handled this with customer via email. Thanks.
|
|