|
Post by silverswarfer on Aug 24, 2017 5:00:17 GMT
Hi guys, ran into a small issue while assembling the V wheels for the Carve King....one of the bearing IDs has an interference fit with the M5 bolts. I tried a few different bolts and all of them bind up after about a thread or two. Is there a good way to bore the ID out a few thou without spinning the inner race? Or should I file/sand the OD of the threads of the bolt a bit? The bearing seems to spin fine and all of the others went together without issue. Trying to think of something that will work cheaply that isn't sticking my Dremel in the ID and hoping the race doesn't spin. Thanks for any ideas! Attachments:
|
|
|
Post by breslinmr on Aug 24, 2017 6:30:30 GMT
Wouldn't recommend drilling out in case puts bearing out of balance or something. Might be worth getting a new bearing I'm sure when Derek sees your post he could send you a replacement. Very good customer service here
|
|
|
Post by jkendall on Aug 24, 2017 12:35:33 GMT
Are you sure that's the right bolt? I've run into this before.
|
|
|
Post by Derek the Admin on Aug 24, 2017 12:46:19 GMT
Let us get you a couple new ones out. Sorry about that.
|
|
|
Post by silverswarfer on Aug 25, 2017 12:16:08 GMT
Let us get you a couple new ones out. Sorry about that. Thanks Derek!
|
|