|
Post by Jerry on Aug 26, 2017 3:37:02 GMT
I needed some mounts made for a car, so I put a 1/2" aluminum plate in there, and with a 1/4" end mill, and a reasonable understanding of expectations, and strateegery and a dash of patience ... The mounts are still secured with a few small tabs, Fusion360 can add them easy. If I did it again I would like to see how a 1/8" end mill or a single flute end mill would do. Jerry
|
|
|
Post by Derek the Admin on Aug 26, 2017 4:30:32 GMT
Looking good from what I can see! Thanks for sharing.
|
|