|
Post by billb0169 on Sept 17, 2017 3:26:28 GMT
I was wondering if it's possible to do a profiling operation in F-Engrave? I'm going to v-carve a circular shaped design on a small piece of wood then I'd like to cut it out (circular profile around the design). Would the profile cut have to be done in another piece of software like Fusion or can this still be done in F-Engrave? Below is a pic from the F-Engrave site showing what I'm shooting for. www.scorchworks.com/Fengrave/mayan1.jpgThanks
|
|