|
|
Post by VGCustomShop on Sept 18, 2017 8:37:23 GMT
Attached are a hand made body and neck - the body is walnut with an arch top - it is too long to center - but diagonally it fits - can this guitar body be routed in this fashion using the Carve King? Also, the neck is too long for the machine - but would it be possible to mill only the profile (the rounded part between the headstock and heel where the guitar attaches to the body) again diagonally? Thanks for any input. The inside of masking tape shows the operating area of the Carve King.   |
|
|
|
Post by Derek the Admin on Sept 18, 2017 11:34:36 GMT
Yes. Just model it, then turn it however many degrees using the "move" command.. Go to the cam workspace and the bounding box around the part will still be oriented normally. Give it a shot and you'll see what I mean .
|
|
|
|
Post by VGCustomShop on Sept 19, 2017 3:56:33 GMT
Yes. Just model it, then turn it however many degrees using the "move" command.. Go to the cam workspace and the bounding box around the part will still be oriented normally. Give it a shot and you'll see what I mean . Many thanks man - this is great news - presents way more options! |
|
|
|
Post by Derek the Admin on Sept 19, 2017 15:20:20 GMT
Glad to hear it.
|
|
