|
|
Post by kec-10238 on Sept 28, 2017 16:05:57 GMT
After 2 months after purchase - made some "me" time to finish my machine (CK). Electronics and I don't get along BUT this was rather easy to do. Don't FEAR the electronics! after testing the power supply (24.7V) and the adjusting the purple things (ranges 649-652 millivolts) - wired her all up and did the jog test. Everything went as it should so am quite pleased. Now onto finishing up the electronic box so I can do some further testing before putting her to work.
|
|
|
|
Post by Derek the Admin on Sept 28, 2017 16:45:34 GMT
Cool. Glad it went okay.
|
|
|
|
Post by kec-10238 on Sept 28, 2017 17:00:03 GMT
yep - assembled the electonics box - did the re-jog test - all is well. I did have to manually install the driver but the universal g-code sender I was using (downloaded from manual v1.09) did not turn red/green just showed it was connected when i opened the connection. I also could not send a feed rate just set the measurement in mm or inches. maybe I should upgrade - idk. does the CK need to be tied down (secured to a bench)? |
|
