Emergency stop for M3

peter
New Member

Posts: 7

Emergency stop for M3 Jan 20, 2018 22:10:01 GMT

Quote

Post by peter on Jan 20, 2018 22:10:01 GMT

I did a search and didn't really find anything applicable.

Is it possible to install an e-stop switch for the steppers. Right now if I have a crash or problem I have to go to the laptop and hit pause or stop in UGS. Can a stop button be placed to just kill the steppers. I am assuming this would mess up the program as UGS would keep sending code. I'd love for the stop to also pause UGS.

Any creative ideas?
Thanks!

Bruce Forum Guru Posts: 2,719 Machine: Carve King	Emergency stop for M3 Jan 20, 2018 22:29:53 GMT Derek the Admin likes this Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by Bruce on Jan 20, 2018 22:29:53 GMT Peter check out this thread: millrightcnc.proboards.com/thread/670/pause-button-wiring-diagram
	Bruce Rogers Carve King, bCNC, Huanyang VFD with 1HP Spindle. 19" Mega V, DeWalt 611

peter New Member Posts: 7	Emergency stop for M3 Jan 20, 2018 23:32:30 GMT Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by peter on Jan 20, 2018 23:32:30 GMT Jan 20, 2018 22:29:53 GMT Bruce said: Peter check out this thread: millrightcnc.proboards.com/thread/670/pause-button-wiring-diagram PERFECT! I never thought to search for "pause". Thanks!!

peter New Member Posts: 7	Emergency stop for M3 Jan 20, 2018 23:37:22 GMT Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by peter on Jan 20, 2018 23:37:22 GMT Damn! I never even noticed right on the board is "hold", "resume", "abort" & "E-stop". Mine is in a project box so I haven't looked at it in a while.

Post by peter on Jan 20, 2018 22:10:01 GMT

Post by Bruce on Jan 20, 2018 22:29:53 GMT

Post by peter on Jan 20, 2018 23:32:30 GMT

Post by peter on Jan 20, 2018 23:37:22 GMT