|
Post by Derek the Admin on Sept 3, 2018 13:44:45 GMT
Do you have any particular points you can call out where you see this bouncing? I watched it and didn’t see that.
I think the material being left in some places is because you are probably cutting the slot with nearly 100% stepover.
|
|
Bubba's Workshop
Full Member
Posts: 166
Location: Ludington, Michigan
Machine: M3
|
Post by Bubba's Workshop on Sept 3, 2018 14:39:18 GMT
I saw it bounce as it was on a long strait cut. Here is a vid I took after it was done maybe this is the reason. www.youtube.com/watch?v=qWq1_deYVJEYa i thought the step over was to much to but i have it set and i think .028 on .063 end mill.
|
|