gisco
New Member
Posts: 15
|
Post by gisco on Jul 17, 2018 19:02:08 GMT
Thanks to AFROWW, Derek and Insohmniac, I have upgraded my control box on the Carve king to have the Hold, Resume and abort functions. I used stuff I had laying around. total cost $0.43. Thanks again.
|
|
|
Post by jimmyk on Jul 17, 2018 22:04:01 GMT
I finally printed out the 3D enclosure for the M3 electronics from Thingiverse, so I thought I would post a pic so you could see what it looks like installed if you were thinking about it. Overall I am happy with it as I feel it is much better protected.
I added some PTFE standoffs between the board and the enclosure so I could tighten it down a little better...
|
|